Start up a site

Before anyone starts work, go through your site startup procedure on your phone, step by step, and put anything wrong on record.

Step by step

1. Open Site startup. Choose the procedure, your crew and the site, then tap Begin startup checklist.
2. Mark each step OK if it is fine, or N/A if it does not apply today.
3. When a step asks for a photo, take it there. Submit startup waits until each required photo is added.
4. If something is not right, mark Attention. Say what you found and what you did about it, and tick Requires further follow-up to raise it as a hazard report.
5. Tap Submit startup. The startup is on record, and anything you flagged goes for review.

Good to know

• Who writes the procedures. Safety managers and administrators set them up under Site startup, Procedure Templates, so every crew starts the same way.
• If a photo does not upload. You are told which step's photo did not go, so you can add it from the Safety log.
• What happens to a flagged step. See Review a hazard.